How to control the installation distance of LED solar garden lights
The main parameter configuration of solar garden light mainly includes: all-steel structure, overall hot-dip galvanized / plastic sprayed light pole. Configure 15-80WP crystalline silicon battery panels according to the load; maintenance-free lead-acid or colloidal batteries, special light control + time control controller for solar energy-saving lighting, during the installation process, the protection level of solar garden lights should reach the IP65 industry standard. If the diffused reflection-free courtyard light is used, the height limit of the pole is required. Generally, the installation distance of the courtyard light should be controlled at 18-20 meters. As the main light source of the road or landscape lighting, in the aspect of solar garden light system control, the interval jumper should be used to control in two ways, so that the solar garden light can save energy and reduce the cost of the street light system configuration in the application process. For the installation of courtyard lights, only when the installation of solar courtyard lights is set according to the engineering installation practice, can the solar courtyard lights achieve a good application in lighting? The main function of solar cells is to convert light energy into electrical energy. This phenomenon is called the photovoltaic effect. Among the many solar cells, three types of solar cells are single-crystal silicon, poly-crystalline silicon and amorphous silicon. The production process of polycrystalline silicon solar cells is relatively simple, the price is lower than that of single crystals, and the conversion efficiency is constantly improving. In the southern regions where there are many rainy days and the sun is relatively inadequate, it is better to use single crystal silicon solar cells, because the electrical performance parameters of single-crystal silicon solar cells are relatively stable. The amorphous silicon solar cell is better in the case of very weak indoor sunlight because the amorphous silicon solar cell has relatively low requirements for solar lighting conditions. But if any problem occurs in any link will cause the product. The solar table lamp consists of a total of parts, namely the solar battery panel charge and discharge controller battery load and the lamp housing.
The courtyard lamp is a kind of outdoor lighting fixture, usually refers to outdoor lighting fixtures below 6 meters, the main part of which consists of the light source lamp pole flange and the foundation embedded parts 5 parts. Nowadays, there is also a kind of garden lamp which is more energy-saving and environmentally friendly, that is, a solar garden lamp. Solar garden lights are now more and more loved by more and more people because it has three innovations. Although the energy that the sun radiates to the earth ’s atmosphere is only one-two billionths of its total radiant energy, it is already as high as 173,000TW, which means that the energy the sun irradiates to the earth every second is equivalent to 6 million tons of coal. Wind energy hydro energy ocean temperature difference energy wave energy and biomass energy and some tidal energy are derived from the sun, even the fossil fuels on the earth are fundamentally stored solar energy since ancient times, so the broad scope of solar energy includes Very large, the narrow sense of solar energy is limited to the direct conversion of solar thermal energy by photothermal photoelectricity and photochemistry.